What i have: ender 3, bootliader installed (prev firmware was marlin 2.0.5.3), octoprint lastest on rpi 2b, slicer: cura 4.6 or craftware —> m420 s1 in slicer setted up
i did as u wrote step by step .
Cant print via octo, because i hot an errormessage: bed level not supported.
Printing error
Dear Daniel!
What i have: ender 3, bootliader installed (prev firmware was marlin 2.0.5.3), octoprint lastest on rpi 2b, slicer: cura 4.6 or craftware —> m420 s1 in slicer setted up
i did as u wrote step by step .
Cant print via octo, because i hot an errormessage: bed level not supported.
can u advise what is missing or did wrong?
Thx, stefan