First of all thanks for your work with this firmware.
but I'm having an issue with it. When I make the bed leveling process the first line and row of the probing test points are to close to the edge of the bed while the probing points are far from the edge on the other two sides of the bed. and the same happens when it prints. So even if a put a print centered in the bed the final print result in be displaced to the down and left side of the bed by a few cm. I don't know how to fix it. I have my ender configured to 235x235. Also when the prints end the X-axis is forced to much to the end-stop as it wants to continue far away.
Calibration and print displacement.
First of all thanks for your work with this firmware.
but I'm having an issue with it. When I make the bed leveling process the first line and row of the probing test points are to close to the edge of the bed while the probing points are far from the edge on the other two sides of the bed. and the same happens when it prints. So even if a put a print centered in the bed the final print result in be displaced to the down and left side of the bed by a few cm. I don't know how to fix it. I have my ender configured to 235x235. Also when the prints end the X-axis is forced to much to the end-stop as it wants to continue far away.
I would like to know how to fix this issues.
Thanks.