Comentar

Hi,

thanks for your FW on Ender3 3DPrinter.

I ask for you... after upgrade the fw of my Ender3 not pro, board original 8bit, the fw 1.1.9 + mesh level is good and the mesh level is right but i lose the configuration of step/mm fron menu lcd on printer. I've set the value correct on firmware before upload on machine but, is very usefully to have on menu to modify the step values.

I can modify on firmware for to have this menu active again?

Thanks

O conteúdo deste campo é privado e não será exibido ao público.
CAPTCHA
12 + 4 =
Resolva este problema matemático simples e digite o resultado. Por exemplo para 1+3, digite 4.
Esta questão é para verificar se você é ou não um visitante humano e prevenir submissões automáticas de spam.
Protected by Spam Master